Abstract:
A simple, accurate and precise UV spectroscopy and RP-HPLC methods were
developed and validated for simultaneous estimation of Valsartan and Cilnidipine in
combination. First order derivative method was developed using methanol as a
solvent. At ZCP of valsartan (248nm) cilnidipine showed a measurable derivative
absorbance where as at zero crossing point of cilnidipine (240) valsartan showed an
appreciable derivative absorbance value. The calibration curve were linear in a
concentration range of 8-48 μg/ml for Valsartan and 1-6 μg/ml for Cilnidipine at their
respective wavelength. In combination both the drugs were estimated in the range
98.50-101.33%. The RP-HPLC method has shown adequate separation of Valsartan
and Cilnidipine in combination. The separation was achieved on a Enable C18
(250mm X 4.6 mm i.d., 5 μm particle size) with an Isocratic system of Acetonitrile : Water (pH 4.4) in the ratio of 80:20 v/v. The mobile phase at a flow rate of 1.0
ml/min, injection volume 20μl and wavelength of detection used was 227nm. The
retention time for Valsartan and Cilnidipine was obtained as 3.711± 0.1min and
7.882± 0.05min respectively. The linearity of the proposed method was investigated
in the range of 8-56μg/ml and 1-7μg/ml for Valsartan and Cilnidipine respectively.
The developed method was validated as per ICH guideline, for its accuracy, precision,
LOD & LOQ and the results were found to be satisfactory, thus the method is
specific, rapid and simple with good sensitivity for estimation of Valsartan and
Cilnidipine.
Conclusion: The above methods ware cost-effective quality-control tool for routine
analysis of Valsartan and Cilnidipine in Combination.
